|
|
he simplest tools to
sharpen are those with straight cutting edges — flat
chisels
and
plane irons.
These tools have a bevel and a back. Initially, you must grind both
surfaces, flattening the back and honing the bevel. But after the first
sharpening, you need only sharpen the bevel. |
|
One of the most common sharpening
mistakes is starting out with an abrasive that’s not coarse enough.
Don’t use medium grits to remove nicks and chips, flatten surfaces, or
change a bevel angle — it costs you extra work. And if you’re using a
sharpening machine, the finer grits may overheat the tool. |
|
Sharpening a Straight Edge
|
|
1
The first time you sharpen a chisel or a plane iron, flatten the back.
Start with a coarse abrasive. Press the back against the stone and rub
it back and forth until the scratch pattern covers the entire back. Work
your way through finer stones, finishing the back to the same degree
that you plan to finish the bevel.
NOTE: Once the back is flat, there’s no need to grind it again. In fact,
you shouldn’t touch it except to briefly rub it across a fine stone or
strop to remove burrs. If you grind the back each time you sharpen the
chisel, the blade will grow thin and fragile.
|
2
Mount the chisel in the tool holder or honing guide so the bevel rests
against the abrasive. If you want to grind the bevel to a new angle, set
that angle with the aid of a protractor. If you want to maintain the
current bevel angle, set the tool so the bevel is flat on the stone.
Make a few passes across the stone and inspect the bevel. If just the
tip is scratched, the angle is too large. If just the heel is scratched,
it’s too small. When the entire bevel is scratched, the angle is right
on the money.
|
3
Start with a coarse abrasive and grind
the bevel until the cutting edge appears keen and straight, and all the
nicks have disappeared. Move to a finer abrasive and hone the bevel at
the same angle. For the sharpest possible edge, continue on through
finer abrasives, polishing, then stropping the bevel. How can you tell
when it’s time to move to a finer stone? Inspect the bevel — when the
surface is an even color and texture with no dull areas or shiny spots,
change to a finer grit.
|
4
As you sharpen, take care to preserve the profile of the blade — the
cutting edge should be straight and perpendicular to the side. If you
inadvertently grind a skew, you can easily correct it with some extra
work and a judicious application of pressure.
|
5
When you’ve finished the bevel, remove the burr that forms on the back.
Turn the tool over and rub the back several times across the last
abrasive used. Don’t remove the honing guide or change the angle of the
tool rest. To remove the last vestiges of the burr, it often helps to
take a few more licks on the last stone or strop, alternating between
the bevel and the back. Test the sharpness by cutting a thin slice
across the grain of a wood scrap. Any traces of the burr will leave tiny
lines of torn fibers in the cut surface. |
|
Back to the top
|
|